Both of your reports lead me to believe something else is amiss in either the install or another, related configuration setting. Problem is, I’m not smart enough to figure out what’s not right. When discovered, it will be a “duh” moment, I’m sure. Thanks for taking a look at your system to check.

Best,

Mike

From: guide-user@yahoogroups.com [mailto:guide-user@yahoogroups.com] On Behalf Of Ldstryker@...
Sent: Wednesday, October 9, 2013 9:15 PM
To: guide-user@yahoogroups.com
Subject: Re: [guide-user] Toggle User Datasets Question

I just tried it myself and it works perfectly using the method above.

Paul...

-----Original Message-----
From: Mike Stewart <mike.n0tu@...>
To: guide-user <guide-user@yahoogroups.com>
Sent: Wed, Oct 9, 2013 10:09 pm
Subject: RE: [guide-user] Toggle User Datasets Question

Mati,

That is the sequence I’ve used--with no luck. The clusters don’t appear on the chart. Changing levels doesn’t help, either.

By the way, I have tried with the M31 images on and off. Neither way works.

Mike

From: guide-user@yahoogroups.com [mailto:guide-user@yahoogroups.com] On Behalf Of Mati Morel
Sent: Wednesday, October 9, 2013 9:02 PM
To: guide-user@yahoogroups.com
Subject: Re: [guide-user] Toggle User Datasets Question

I’ve tried it myself, and it works fine. To be sure you haven’t skipped anything, in the dialog box for <M31 Globular Clusters>, do the following

click “on”, then

click “OK”.

This will take you back to the previous dialog box, then

click on “Done”.

Nothing more to do.

Regards,

Mati Morel
Variable Stars South
mmorel7@...

[Non-text portions of this message have been removed]