Hi Dave,

On 01/16/2013 04:42 PM, dspooner89 wrote:
> I've installed the 20.12.12 update which works fine standalone.
> However, it now crashes when connecting to the scope with the
> error messages 'Guide8 MFC Application has stopped Guide9.exe -
> no debugger found. No registered JIT debugger was specified'.

Um. A very odd message indeed...

First off, I'm assuming this is an ASCOM setup, rather than
using Guide's direct controls? What sort of scope are you using?

At what point does the crash occur? (In the scope setup
dialog? When trying to slew the scope or read its coordinates?)

-- Bill