P. Clay Sherrod Apr 15, 2012
----- Original Message -----
From: "lone_scope2000" <lone_scope2000@...>
Sent: Sunday, April 15, 2012 5:56 PM
Subject: [guide-user] Re: Error message while slewing
> Hi Doc,
> Thanks for chiming in, especially on a weekend day off!
> I usually do forget to state specific information when posting, it is
> usually more of an afterthought that I do.
> The message I get is always different after each slew, it just states
> "error: (and then a number, the part that changes each time)" as for the
> baud rate of the control computer I will have to check that after the bad
> weather passes through, at present I have things unplugged and turned off
> in my observatory.
> --- In firstname.lastname@example.org, "P. Clay Sherrod" <drclay@...> wrote:
>> Hello Dave....
>> I know that you have reported this problem a couple of times with no
>> response; since I do not know what might be happening I have no advice
>> you; can you please state the wording of the error message that you are
>> Also, check your baud rate on the serial connection that you are using
>> your PC and see if it is perhaps set either to high or low....there is a
>> sending and a receiving rate.
>> Hopefully Bill or someone will chime in here pretty soon.....I remember
>> seeing your question over a month ago.
>> Dr. Clay
>> Arkansas Sky Observatories
>> MPC H45 - Petit Jean Mountain South
>> MPC H41 - Petit Jean Mountain
>> MPC H43 - Conway West
> To unsubscribe from this group, send an empty email to:
> email@example.comYahoo! Groups Links