Guide 9/LX200GPS usage

lone_scope2000 Apr 8, 2012

I have been using Guide 8 on an older Gateway desktop to control my 12" LX200GPS for the past few years. A few months ago after sending a slew command to the telescope things seemed to go fine until near the very end of the slew when an error message would pop up on the Guide 8 computer though the slew fully completed accurately. For those who are using Guide 9 and an LX200 series telescope has anyone noticed similar behavior? Bill had given me a command to enter via the Alt-J prompt but for the life of me I can not find where I put the note I made of it.

Thank you