Hi all,

I've already mentioned this to Bill and have posted a similar plea on
the scope-drive group.

My problem is that I would like to use Guide with Scope which has a
command "Guide.bat" which is specifically designed to invoke Guide and
pass parameters between the two programs so the telescope and guide
stay in synch.

Guide should appear when this command is chosen, but the only thing
that happens is that the screen blinks and (I believe) parameters are
passed. No Guide shows up. If I try to run Guide from in DOS (either
with the guide.bat file or directly), it goes, but the cursor is frozen.

I've installed the programs as per advice in the archives of the scope-
drive group, but there's no joy.

Anybody have a similar problem? Solution??

Jer