Use the P4-W2k machine, or try Windows Update/Vendor Patching on
the AMD Win98SE machine. Most likely the AMD machine has a Via or
Ali chipset. These 3rd party chipsets from a few years back (K6 &
early K7) can be a headache. Even early AMD chipsets need some
patching. Via has service packs that can address some issues for
thier chipsets. Windows Update can solve some of the "Files not
found" issues.
As for the Meade software side of the equation, they are probably
going with Microsoft's position in that Win98SE has run it's course
and the testing there is probably limited to Intel.
Most software these days is tested/supported primarily with XP and
W2k for a backup.

RobertB

--- In guide-user@yahoogroups.com, sargentg@g... wrote:
> First Meade CD corrupt, second loads OK. Computers have MSIE v 6
> and the net-dot loaded fine. On "P4" machine with win2000 on the
> LPI Imager page message says "dsnph71.ax" file can't be found and
> efforts to load it from the Meade CD were just a continuous
repetiton
> of the same. Checked C: drive and the file, and the many files
> derived from it (about 9) were "all over the place" so reverted to
> trying the Meade CD again but used the command "skip file" - then
> "lo and behold " it works. Nice device.
>
> With Win 98SE, on a Tyan using a 450Mhz AMD processor, or Toshiba
> Satellite Pro 4080 and ditto 440CDT, on the image page get small
> windo saying LPI not found disconnect and try again. This has been
> an "on going saga" over a week. Many reinstallations of O/S and
> Meade software. Dealer can't help.
>
> On these computers I have everything at one time or another, Mira,
> SBIG USB Cameras, StarlightXpress USB cameras, Maxim so on and so
> forth and never a blink of trouble so for me it is the software
> that is demonstrably at fault - help please, Gerald.