When creating a Star Trail for the asteroid 1999 KW4 with the recent update
installed the time was printed at the correct intervals but in UT time. Is
there any way to change it so it prints the same time as that selected in "Time
Zone set-up". In my case Mountain Daylight Time.

I know it won't be a problem in most cases where you are plotting for slow
moving objects. But for 1999 KW4 I had a trail with seven - 30 minute
intervals.

The orbital elements I got from the MPC site must have been a bit dated because
the Asteroid was about 5 minutes (time wise) ahead of and 20 to 30 arc-seconds
to the right of its position as plotted in Guide.

Larry Wood
chukwood@...