Hi Eric,

Clay's right, the 16200 isn't in there. Try this (should
replace a file currently in your Guide folder; if you don't get
the "overwrite this file?" message, you're not in the right place) :

https://www.projectpluto.com/ccds.nam

The 16200 should then appear.

On a quick read, I'm not quite sure where the guiding chip is
supposed to go (what the separation is between it and the main imaging
chip). I may have to update this... however, it'll get your main
imaging chip right. And the guiding chip, too, but maybe not
exactly where it's supposed to be.

-- Bill

On 2017-10-29 19:35, eric@... [guide-user] wrote:
>
>
> This is probably an obvious question. But how do you set up the FOV of the CCD Frame and Guide chip Frame? We have use one setup so long, can't remember how this is done. We are going from a 16" f/9 to an AP RH f/3.8 and changing from an SBIG STXL 11002 to an SBIG STXL 16200.
>
>
> Help would be appreciated. Thanks.
>
>
> Eric
>
>
>
>