In Guide9’s “guide.dat” file the Imaging and ‘onboard’ Guiding chips are specified.  How can an “additional” Guide chip and Range Rings be added “without removing” the original Guide chip and its Range Rings?  Also, how can the new chip be displayed at different orientations than the onboard Guide chip?  I’ve tried several ways to no effect.  I’m poking in the dark because nothing is found in Guide8’s Manual.  

 

GUIDER_CHIP=0,.6231,.1313,.1477,640,480            (my STL11000M)

 

Has anyone devised a way of displaying ”two” Guide chips and Range Rings in Guide9?  Thkx...joe  :)

"May He Go Among the Imperishable Stars"
Joe Mize, StarFields Observatory,
Chiefland Astronomy Village
http://www.cav-sfo.com/indexarchive.html